Sliding-Patio-Doors-Repair-Its-Not-As-Difficult-As-You-Think-f

Sliding patio door repairs near me is possible for sliding patio doors to become difficult to open and close. This could be due to many issues, such as dirty tracks or a misaligned slider.

Start by cleaning and lubricating your rollers. You can also adjust the rollers by using the adjustment holes on the bottom of the door panel with movable doors.

Dirty or Damaged Track

A dirty or damaged track can cause a sliding door to not move properly. Over time dirt, grit and even rust could build up making the track unable to slide smoothly. A gentle detergent and brush will suffice. It is recommended to complete this task frequently to ensure the smooth operation of your door and prevent the need for costly repairs later on.

A leaky door can be a common problem. It requires immediate attention in order to prevent structural deterioration, water damage and the growth of mold. The issue is usually caused by worn weather stripping and misaligned doors. This can be fixed by replacing the old weather stripping and aligning the doors.

Rollers that jump off the track are another common issue that can be solved with a few minutes of DIY work. Get a partner to assist you with this task as the door could be heavy. To move the rollers around to the right position, sit inside the house and lean one of the panels towards you. To stop the panel from falling, place it on sawhorses when it's been removed from the bottom track. Then, loosen each roller's screws and remove them with the help of a screwdriver. You can now clean any dirt that has accumulated between the wheel and the tracks. Then, clean each wheel with denatured alcohol and a rag, then reposition the wheels and reconnect them to their tracks.

If a part of the track is bent, it may be possible to straighten it by using a rubber mallet and block of wood. However when the bent section is near the hinges and is likely to cause more damage, you'll be better off calling a professional for safety reasons.

Misaligned Rollers

If your sliding door is having a problem sliding, it's likely that the roller wheels have been misaligned. The wheels could be dirty or rusted and their bearings are worn down. This friction causes the door to catch and grind when it's opened or closed. It can also cause sounds that squeak.

This is a straightforward fix. The wheels are attached to the bracket, which can be adjusted, so you don't have to remove the door. Use a screwdriver to find the adjustment holes on the frame (usually either side). Rotate the screws to control the wheels. A clockwise rotation of the screw raises the wheel, while a counterclockwise movement lowers it. Continue to adjust until the door moves smoothly and quietly when open or closed.

It is important to adjust the wheel prior to adjusting your latch. The latch hooks must be aligned with the strike plate (the opening through which the latch locks) in order for the lock to function properly. If you don't do this, the latch could accidentally open or close while you're out of the room.

Patio doors that slide are a major investment, and ensuring they are working properly will keep your family safe and secure. By addressing common problems like broken tracks, rollers and handles, you can avoid expensive repairs in the future. If you need help with your patio doors, contact our team. We can help keep your sliding patio doors in great condition by assessing the repair requirements. Our professionals can also help with any replacement parts you might require.

The door frame is sagging or damaged

Sliding patio doors are an excellent option for any home. They provide a convenient and attractive alternative to hinged or swing-open patio door options. Like any other hardware item sliding patio doors are prone to be prone to problems over time. A lot of these issues are fixable by using a bit of DIY expertise.

A gap in the frame is a common problem with sliding patio doors. This could be due to a number of reasons, including a an improperly aligned track or rollers or a damaged track door, or a bowed door frame. In most cases, this problem can be easily fixed by taking the doors off and reattaching the track. This must be done with extreme caution to avoid harm the track or frame.

In certain situations it is necessary to replace the entire track. This can be easily accomplished using a universal replacement kit which is available at most major hardware stores. These kits are easy to install and will have your door functioning properly again in no-time.

It is essential to regularly inspect your sliding door frame and hardware for signs of wear and tear, for instance loose bolts or screws. This is a simple and efficient DIY patio maintenance procedure that can be done with an electric screwdriver. It is also important to grease your tracks and rollers to facilitate smooth operation and to prevent premature wear.

For many homeowners the patio doors are the primary access to their backyard and outdoor living space. As such, they need to be able to function properly to maintain the comfort of their home and provide security. By taking the time to follow these simple DIY maintenance steps homeowners can extend the lifespan of their sliding patio doors and reduce the cost of repairs or replacements.

Faulty Handle

Sliding patio door are ideal for allowing you to enter your home and gain access to your backyard, however they can be difficult to operate if they are not aligned properly. A defective handle can cause the door to not open or close properly. Repairing a damaged handle can be done at home.

In most instances, a loose handle is merely the result of screws that have made their way out of the backplate. To fix this issue you can simply tighten the two screws that are on the inside of the handle using the help of a screwdriver. If the handle is still loose, it could indicate that the threads have worn away and need to be replaced.

A broken latch may be the reason. It is more likely that the latch will break if it is made of metal instead of plastic. If the latch is not catching or turning, you should try oiling it first to see if this can help. If this doesn't work, you may need to replace the lock.

The handle, in turn, may become difficult to operate when it is damaged or damaged. If this happens it is necessary to replace it with a new handle that is in line with the design of your sliding patio door.

Whether your patio doors are old and outdated or brand new, Feldco can help you get them back on the right track. We offer high-quality doors in different sizes and styles that can be adapted to match your home perfectly. To find out more about our products, contact us today! We provide services to Southern California homeowners, including Ventura County and Orange County.

Afflicted Weatherstripping





If you're seeing light around windows and doors that are closed or notice a draft pulsing on the door or window, it's time to replace your weather stripping. The strips form an airtight seal, which stops unwanted water, air, and pests from entering your home. This helps keep your conditioned and heated air inside, saving you money on energy bills.

Depending on the condition of your weather stripping, it may have deflated, and lost its bouncy positive seal. It is easy to determine this by running a dollar bill under the seal at the top and bottom of the jamb as well as the door frame, where they overlap. If the dollar bill slides easily between the seal and door easily then it's time to replace the weatherstripping.

If you replace only the worn-out part of the weather stripping, it could cause problems in the future with the seal. It is more efficient to replace the entire stripping. This will allow you to be assured that your door will be properly sealed.

Follow our DIY guide to weather stripping to put the correct material on your sliding patio door and frame to ensure a secure and long-lasting seal. It's a great method to fix your door and reduce your energy bills Don't wait until it's too late. You'll be able to save money and improve the appearance of your home.