14-Common-Misconceptions-About-Fiat-500-Replacement-Key-Cost-j

Fiat 500 Replacement Key Fob

If your 500 remote key fob isn't functioning, it could be time to replace the battery. If you do replace the battery and it continues to stop working then the issue is probably elsewhere.

At United Locksmith, we specialize in the creation of new keys for classic automobiles. We have the tools and spare parts needed for this service.





fiat car key cutting that your Fiat 500 key fob will not lock or unlock the doors is a dead battery. The key fob comes with an internal battery called a coin cell which will quickly drain when it isn't being utilized frequently enough. If your remote has started to show signs like a loss of range or stopped working in the middle of the night, then your battery may be dead.

Metal clips keep the battery securely in the key fob. If the clips are loose, it can cause problems with contact, which can prevent your remote from receiving power. Make use of a flathead screwdriver to pry open the retaining clip and then remove the old battery. Make sure you use a replacement battery with the same type of voltage, dimensions and specifications as the original battery.

Water exposure can cause the key fob to corrode or be damaged. Even a brief bath in soapy water can cause damage to the electronic chip inside. It is best to keep your key fob in a dry area.

Water Damage

If your key fob isn't working properly, it may be due to water damage. Key fobs have rubber seals that stop them from being damaged by light rain or splashes of water. However, it is essential to keep your car keys out of the pool, ocean and the washing machine!

The key fob is equipped with an electronic chip which sends an immobilizer system of your car. This is what allows your 500 to start or lock, but in the event that the chip becomes wet, it's unable to longer function.

Try cleaning your key fob's internal electronics using isopropyl alcohol, or an electronic cleaner to determine whether they're still in good condition. It is recommended to replace the key fob when it has been submerged into salt water, rather than trying to fix it yourself.

While a replacement fob can cost a little money, it's a lot cheaper than having to pay for your Fiat 500 to be towed to the dealer and repaired! In addition, you can make it yourself in just the simplest of steps. Be sure to use the right battery type before you attempt to open your key fob. This is a job that's much easier than it looks, and there are step-by-step instructions online for almost any key fob for your car.

Faulty Chip

The chip that is contained in the key fob communicates with your car's immobiliser system to ensure the car is capable of starting when the correct key is used. If the chip is damaged or corrupted in any way it will not start.

Water damage or a dead phone battery are among the most frequently cited reasons for defective chips. It is best to delegate the work to a professional locksmith who can repair the chip quickly and at a reasonable price.

If your key fob ceases to function after exposure to clean tap water or rain, take off the battery and wipe down the electronic component with a tissue to ensure it's dry before putting it back into. If the key fob does not function, there's the possibility that it has damaged components and requires to be replaced.

A few people will visit their dealer in order to get an entirely new Fiat fob. However, this can be an expensive option. If you are looking for a cost-effective way to get your Fiat key fob fixed Look no further than United Locksmith. We have the tools and expertise necessary to fix your Fiat key fob in a timely and professional way.

Faulty Receiver Module

Fiat key fobs transmit a signal to the vehicle which will unlock and lock doors (and start the vehicle for those with an automatic transmission) up to 50 feet. However, there are a few things that can cause the fob to cease working. This could be due to a dead coin battery, water damage buttons, worn ones as well as a receiver module problem and signal interference or a malfunctioning electronic chip.

If the fob was placed in a pocket which has suffered extreme trauma (such as being dropped on a hard floor or being washed in the washing machine) the fob may not be able to connect with the Body Control Module (BCM) of the car. The BCM is a security system that will only accept signals from genuine keys.

You'll have to replace the fob if this happens. A locksmith professional can handle every aspect of the key replacement procedure and can even program a brand new one for the 500. In fact, they'll offer you a clone key that functions like the original fob (and costs only a fraction of the price).