A-StepByStep-Guide-To-Kia-Picanto-Key-Fob-Replacement-From-Start-To-Finish-d

How to Replace a Kia Sportage Replacement Key

For many Kia models keys, there is the keyless entry system that is built into the key. The key functions like the remote control and can be exchanged with a Kia dealer.

Key fobs may stop working due to a variety of reasons, such as the battery being dead, worn-out buttons signal interference or water damage. Here are some helpful tips on how you can get your Kia Sportage replacement key to work again.

How to replace the remote key or smartkey

No matter if your Kia is equipped with an intelligent key, remote key, push to start key or a standard non-transponder key made of metal The battery inside these keys will eventually require replacing. This is especially true if your car displays a message telling you that the smart or remote keys are in poor condition.

It's a fairly simple procedure. To replace the battery of the keyfob remove your mechanical key from the slit at the back of the fob. Then, pull the cover open. Inside the key fob there will be tiny screws that hold the battery in place. Utilizing a small screwdriver loosen the screw and remove the battery that was in place. Insert the new battery and then close the gap on the key fob.

Test the key fob by pressing the lock or unlock buttons. If the doors lock and unlock according to your expectations, then you're good to go! You can now take advantage of Kia's hands-free lock/unlock function whenever your fingers feel cold or you need to go on errands around Brandon.

Note: Certain key fobs could need to be programmed (transponder chips or smart keys). This requires a machine for programming that is available only to the locksmith for cars or dealer. Other keys (non transponder metal keys) do not require programming. If your key requires to be reprogrammed, you must know the key code number printed on the tag that identifies the key and record the number in a secure place.

How do I replace the battery?

If the Kia key fob doesn't respond when you press the lock/unlock button, it's a sign that the battery is depleted. A low battery may also cause other problems like the check engine light turning on or delayed cranking of the engine. It is relatively easy to replace key fob batteries using just two tools.

Make sure that you shut off your vehicle and close the doors before you begin. Find the small, metal or plastic piece on the bottom of your key fob and jiggle it until a metal key pops out. This key can be put into the driver door handle to unlock your car.

To replace the battery inside the key fob remove the cover that covers the rear. Use a plastic pry tool to loosen up the latch that holds the black negative cable. Remove the old battery, and then position the new battery to ensure its "+" side is facing you and the "-", negative side is facing the fob's electrical contacts. Avoid using excessive force when pushing the new CR2032 into position to avoid damaging or breaking the metal contacts.

After the new battery has been installed then turn the key fob off and back on in the ignition for a few times until the door locks cycle. You can then test the Kia's Key fob again to confirm that it's functioning properly.

How to replace the smart key?

Depending on the model of the Kia Sportage, you may have the standard key fob, or a smart key. The difference between the two is that the smart key has a small mechanical key blade tucked inside it, while the standard fob doesn't. Both kinds of key fobs contain batteries that eventually will need to be replaced. It is a simple process that takes just two minutes.

Make sure you turn off your Kia, and be on a flat, well-lit surface before you begin. Keep in mind that there are tiny pieces inside the fob that can be removed if not cautious.

The first step is to find the small release button on the back of the lower part of the fob. This will be either a circular button or rectangular slot. When you press it mechanical key blade, it will appear and you will be able to open the key fob.

Once the key fob is open, remove the battery that was in it. The new battery is a CR-2032 that can be purchased online or at a local auto parts store. After installation with the battery, you should be able to lock, unlock and start your vehicle with your key fob - even if your engine isn't running!

How do you replace a mechanical key





The Kia keyfob is a wonderful convenience which allows us to lock or unlock our car simply by pressing the button. As with all devices like a key fob, the Kia may have issues. Luckily, there are methods to fix these issues and keep our key fobs in good working condition for the long term.

A dead or weak battery is one of the most frequent problems. This can cause the device to stop working entirely or stop working at times. If this happens, try replacing the battery with a fresh new one.

If this does not resolve the issue, you can use a standard flathead screwdriver to wedge the fob's plastic casing open. Be careful not to scratch any internal components or scratch the plastic. After opening, carefully remove kia replacement car keys have been using and replace it with a brand new one.

After the new battery has been put in, close and open the doors using the mechanical key (every Kia fob comes with an emergency mechanical key that will fit into the slot). Test the key fob and check that it's functioning correctly. If the fob isn't working, contact a locksmith or dealer to help solve the problem. Make sure they cut you an emergency key that functions across all trunk and door cylinders, to avoid future lockouts.