Car-Window-Tinting-In-Richmond-VA-h

DIY Car Window Tinting: 15 Simple Steps

Car window tinting could be a surprisingly manageable task. Follow the steps below meticulously to achieve flawless tinting for your car home windows:

Gather all the supplies wanted for the automobile window tinting process before beginning.

Use the outside of your automotive window as a template and cut sheets of tangible dimension for all windows in one go, avoiding the necessity to cut each sheet individually.

Spray a mixture of water and cleaning soap on the aspect home windows.

Use a razor to remove any residue.

Employ a 4-inch squeegee to remove residue, ensuring it is pushed out of the film.

Apply the tint to the window, leaving about 1/4 to 1/16 inch from the top edge to account for protection when the home windows are rolled up and the doors are closed.

Press the tint into the internal rubber seal of the car window.

Use a card to ensure the movie reaches each corner evenly.

Use a hand dryer over the window to make sure a clean adhesion, drying till there is not a moisture between the tint film and the glass.

Apply tint to the entrance car window following the same technique.

Repeat the process for the back automobile window, guaranteeing no steps are skipped.

Count the variety of defroster heater traces on the again window.





Cut the rear window movie sheet into the required panels.

Overlap the panels and determine the heater traces where they intersect.

Trim as needed for automobile window tinting Richmond VA .

Follow these steps fastidiously, and you can achieve professional-looking automotive window tinting without spending a fortune..