The-Top-Reasons-People-Succeed-At-The-Fiat-500-Replacement-Key-Cost-Industry-r

Fiat 500 Replacement Key Fob

It might be time to replace the battery if the 500 remote key fob is not working. If you do replace the battery but it continues to stop working it could be elsewhere.

At United Locksmith, we specialize in making new keys for old cars. We have the tools and components required for this service.

Dead Coin Battery





A dead battery is the main cause of your Fiat 500 keyfob not locking or unlocking the doors. The key fob contains the battery of a coin-cell that will drain quickly if it is not utilized frequently enough. If your remote started to show signs of weakness such as a loss in range, and then stopped working completely it is likely that the battery is dead.

Metal clips hold the battery in in the key fob. If the clips are loose they could cause contact issues that will stop your remote from receiving power. With a small flathead screwdriver, pull the retaining clip to remove the battery, and replace it with a brand new one. Make sure to use a battery with the same size, voltage and specification as the original.

Exposure to water can cause the key fob to become corroded or damaged. Even a quick bath in warm, soapy water can damage the chip. It is recommended to keep your key fob in a dry location.

Water Damage

Damage to your water supply could be the cause of your key fob's inability to function properly. The rubber seals on key fobs prevent them from being damaged by a light splash or drizzle of water. However, it is important to keep the keys out of the washing machine, the ocean, and pool.

The key fob comes with an electronic chip inside it that sends a signal to your car's immobilizer system. The chip is what allows the 500 to lock and start. If it gets wet it will cease to work.

If you're looking to determine if your key fob is functioning you can clean the internal electronics using isopropyl or an electronic cleaner. However, it's best to get a replacement from a dealership rather than trying to repair the key fob that has been submerged by salt water.

While a replacement fob could cost you a little bit of money, it's much cheaper than paying for your Fiat 500 to be towed to the dealer and repaired! Plus, you can make it yourself in just only a few steps. Be sure to have the correct type of battery before attempting to open your key fob. You can find step-by-step instructions for every car keyfob online.

Faulty Chip

The chip in the key fob communicates with the vehicle's immobiliser to ensure that your car is only capable of starting when the correct key is used. If the chip is damaged, or corrupted in any way it will not start.

Damage to the water or a dead cell phone battery are among the most frequent causes of defective chips. Regardless of the reason, it's a good idea to leave the job to a locksmith who will be able to repair the chip fast and at a low cost.

If your key fob fails to function after exposure to clean tap water or rain, unplug the battery and wipe down the electronic component with a paper towel to ensure it's dry before putting it back in. If the key fob doesn't work, it is likely to be a damaged chip and will require replacement.

Some people will go to their dealer when in need of an entirely new Fiat key fob, but it can be a expensive option. If you are looking for a low-cost solution to have your Fiat key fob repaired Look no further than United Locksmith. We have the tools and knowledge required to repair your Fiat key fob in a quick and professional way.

Faulty Receiver Module

Fiat key fobs send an electronic signal to the vehicle that will unlock and close doors (and start the car for those with an automatic transmission) up to 50 feet. However, there are a few factors that can cause the fob to stop working. fiat 500 key fob replacement could be due to a dead coin battery water damage buttons, worn out buttons and a receiver module issue and signal interference, or an electronic chip that has failed.

If the fob was placed in a pocket that been subject to extreme trauma, like falling on hard floor or being washed in a washing machine the fob may not be capable of communicating with the car's Body Control Module (BCM). This is because the BCM is an extremely secure system that will only accept a signal from a genuine original key and not any other.

You will need to replace the fob in case this happens. A professional locksmith can handle every aspect of the replacement process, including programming a new one for the 500. In fact, they can even provide you with a clone key that functions exactly the same way as the original fob (and costs less than the cost).