Three-Greatest-Moments-In-Car-Key-Cover-Fiat-500-History-s

fiat key

If your 500 key fob isn't working Try a different one to see if the car will recognize it. If it does, the problem is probably with the battery or water damage on the original fob.

First, replace the battery. The "+" side should be facing down.

Dead Battery

The battery is often the reason behind a fob not working. It's a simple fix Most fobs notify you that the battery is running low. There are instructions for the majority of car fobs on YouTube or in your owner's guide. You can also change it by taking it to the locksmith or dealer who has sold it to you.

Sometimes a fob will stop functioning due to a malfunction on the circuit board inside. This is a bit rare but it is possible to occur. If you drop the fob onto something hard, it could damage the internal chip. It can also happen if you are using an aftermarket fob, and the key doesn't work. In this case it is imperative to go to a dealer or locksmith to have the key reprogRammed so that it works with your 500.

One 2012 FIAT FIAT 500 flip key remote - Looks-alike Ilco with lock, unlock, and trunk buttons – new keyless entry replacement (will need to cut & program by locksmith).

Damaged Chip

A key fob with the fiat 500 number is an electronic device that transmits the signal to the car to start after you press the button. It has a microchip that contains information about the code that will allow it to communicate with the car. If the chip is damaged it won't transmit the correct code, and the car won't start. It's possible to repair this kind of damage, and a locksmith can help. United Locksmith can complete this repair on both classic and modern models, so don't hesitate to call us.

Locksmiths can program the new key fob. This is much less expensive than going to a dealer and will work similarly. Locksmiths will require specific details from you, like the year your car was manufactured as well as the model's name.





Rub the chip with an old dollar bill if you're not certain of what to do. The copper in the bill is abrasive and will remove dirt and oxidation. However, it will not cause harm to the microchip. If the chip is physically damaged, it might not be in a position to be repaired. This could happen if you fall it, ram it over with your vehicle or experience any other kind of physical strain.

Water Damage

Water damage is likely to happen on your key, regardless of whether you dropped them in the water accidentally or left them in a pocket while swimming, or splashed them with water during a rainy afternoon. Even if it's just a tiny amount of water on the key, it can cause serious issues with its electronics and hinder it from working properly.

The good news is that you can often fix this problem by removing the fob's key and then using a paper towel to clean it of any dirt or water that remains. When the fob is dry you can then replace its battery and it will start working properly.

You can also take your fob to a local locksmith or auto shop to have it professionally cleaned and programmed. These experts can make use of special equipment to make sure that the key fob works with the car's computers.

If the key fob on your Fiat 500 stops working, you may feel frustrated and anxious. You may be tempted go to the dealer to get your key fob replaced however, this can be expensive and difficult to arrange. A locksmith can replace your key fob without needing to visit an establishment. They are a better option than a dealer, as they can handle all aspects of your car's key fob replacement without the need for a dealer visit.

Pairing Issues

When you drop your key fob, or it stops working but there's nothing wrong with it there could be a chip that has gone off the rails. This could be due to water damage or an unresponsive battery.

In most cases, this can be accomplished by following the directions in your owner's guide. However it's recommended to hire an automotive locksmith assist you if you're experiencing difficulties or the steps in your manual aren't working for you. This will ensure that the chip isn't fried and will likely be the most cost-effective solution.

Another issue facing 500 owners is that the key fob can't secure the car. resources can be a big issue if you're driving to an gas station to refill. Full Posting have reported their 500's locking mechanism failing and having to replace the entire intermediate shaft for steering. This issue was cited in a technical service bulletin (TSB) issued by Fiat.

If you're having issues with your Fiat, an experienced locksmith could help. They'll duplicate your key or design new keys that unlock and start your vehicle. They're able to do this without ever seeing your old key and are usually less expensive than buying it from the dealership.